Audi Q3: General, Technical data
Body / Audi Q3 (8U) 2011-2018 Service Manual / General, Technical data
READ NEXT:
Safety Precautions
Start/Stop System Safety Precautions
Pay attention to the following when working on a vehicle
with Stop/Start system:
WARNING
There is a risk of injury if the engine starts
automatica
Airbag Fasteners, Checking After a Collision
All damaged securing pieces must be replaced, you cannot
reshape components or "make them fit".
The following components must be checked after every airbag
deployment.
With a passenger airbag deSEE MORE:
Bumper Cover Lower Section, Removing and Installing, Audi Q3
Removing
- Remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Remove the front bumper cover end plate. Refer to
→ Chapter "Front Bumper Cover End Plate, Removing and
Installing".
- If equipped, disconnect the connector
Glove Compartment Handle, Removing and Installing
Special tools and workshop equipment
required
Locking Pin (3 pc.) -T40011-
Removing
Note
If glove compartment cover does not open, it can be opened
via the emergency release. Refer to
→ Chapter "Glove Compartment Lid Emergency Release, Operating".
- Press the glo
© 2019-2026 Copyright www.auq3.net | 0.0117
