Audi Q3: Speed warning system
Description
Applies to: vehicles with speed warning system
The speed warning system helps the driver to stay below a specified maximum speed. A warning threshold can be set in the MMI for this purpose.
Once the speed slightly exceeds the stored threshold, the speed warning system will alert the driver with an indicator in the instrument cluster and a warning tone. Once the speed drops below the stored maximum speed, the indicator will turn off.
Setting a threshold is recommended if you would like to be reminded when you reach a certain maximum speed. Situations where you may want to do so include driving in a country with a general speed limit or if there is a specified maximum speed for winter tires.
Tips
Regardless of the speed warning system, you should always monitor your speed using the speedometer and make sure you are following the legal speed limit.
Setting the warning threshold
Applies to: vehicles with speed warning system
- Applies to: MMI: Select on the home screen: VEHICLE > Driver assistance > Speed warning.
Messages
Applies to: vehicles with speed warning system
The following messages may appear depending on the vehicle equipment:
.png)
Manually set xx mph (km/h)
warning
threshold exceeded
The stored speed was exceeded.
READ NEXT:
Camera-based traffic sign recognition
Description
Applies to: vehicles with camera-based traffic sign recognition
Fig. 92 Instrument cluster: traffic sign recognition
The traffic sign recognition shows the traffic
signs detected by the f
Traffic light information
Description
Applies to: vehicles with traffic light information
Fig. 93 Instrument cluster: traffic light information display
The traffic light information gives you a speed
recommendation in order tSEE MORE:
Belt Fastening Detection
Front Passenger Occupant Detection Sensor -G128-, Removing and Installing
Note
The passenger occupant detection sensor is only installed in
the front passenger seat.
Special tools and workshop equipment
required
Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A-
Only for
Front Pull Handle, Removing and Installing
Front Pull Handle, Removing and Installing
Removing
- Remove the armrest. Refer to
→ Chapter "Front Armrest, Removing and Installing".
- Disconnect the connector for the window regulator control
head.
- Driver side: disconnect the connector for the Mirror
Adjusting Sw