Audi Q3: Cleaning/changing wiper blades
Fig. 46 Windshield wipers: changing the wiper blades
Wiper blade replacement position
- Switch off the ignition and hold the windshield
wiper lever in position 4 fig.
44 until
the windshield wiper moves into the wiper
blade replacement position.
- To bring the windshield wipers into the normal
position, switch the ignition on and hold the
lever in position 4 until the windshield wipers
go back to the original position, or drive faster
than 8 mph (12 km/h).
Applies to: MMI: You can also activate or deactivate
the wiper change position in the center display:
- Switch the windshield wipers off (position 0
fig. 44).
- Select on the home screen: VEHICLE > Settings
& Service > Wiper change position.
Cleaning the wiper blades
Requirement: the windshield wipers must be in
the wiper blade replacement position.
- Fold the windshield wiper arm away from the
windshield.
- For information on cleaning.
Replacing the wiper blades
Requirement: the windshield wipers must be in
the wiper blade replacement position.
- Fold the windshield wiper arm away from the
windshield.
- Hold the wiper blade firmly.
- Press the locking knob 1 on the wiper blade.
- Remove the wiper blade from the windshield
wiper arm mount 2.
- Insert the new wiper blade into the mount on
the wiper arm until it clicks into place.
- Place the wiper arm back on the windshield.
- Exit the wiper blade replacement position.
WARNING
- For safety reasons, the windshield wiper
blades should be replaced once or twice
each year.
- Dirty windshield wiper blades can impair vision,
which increases the risk of an accident.
Note
Tips
- You can also use the wiper blade replacement
position for other reasons, for example
if you want to protect the windshield
from icing by using a cover.
- You cannot activate the wiper blade replacement
position when the hood is open.
READ NEXT:
Fig. 47 Rear window wiper: installing the wiper blade
Cleaning the wiper blades
Fold the wiper arm away from the rear window.
For information on cleaning.
Removing the wiper blade
Fold the wipe
Switching the compass on and off
Applies to: vehicles with digital compass
Fig. 48 Rearview mirror: digital compass is switched on
To turn the compass on or off, press the button
1 until the compa
SEE MORE:
Display and Control Head, Removing and Installing, A/C Control Module
-J301- (Heater Control Module -J65-)
Note
Only for vehicles with a manual climate control system
(heater without Air Conditioning (A/C) system).
The Heater Control Module -J65- (for vehicles without an A/C
sy
Left/Right HID Headlamp Control Module -J343-/-J344-, Removing and
Installing, through MY 2014
Removing
- Remove the headlamp housing. Refer to
→ Chapter "Headlamp, Removing and Installing, HID and LED
Headlamps".
- Remove the bolts -arrows-.
- Remove the control modu