Audi Q3: Do It Yourself
Do It Yourself
READ NEXT:
General information
Park the vehicle as far as possible from moving
traffic in the event of a breakdown. In the event
of a flat tire, park the vehicle on a level surface.
If you are on a steep hill, be especially ca
Changing a tire
Preparation
You must complete the preparation before
changing a tire.
Read and follow the important safety precautions.
Set the parking brake.
Select the "P" position.
When towing a trailer: discSEE MORE:
Tire pressure
Fig. 156 Driver's side B-pillar: tire pressure
label
Fig. 157 Tire pressure label
The correct tire pressure for tires
installed at the factory is listed on
a label. The label is located on the
B-pillar (driver's side) fig. 156,
fig. 157.
Use the tire pressure specified for
a normal vehicle load
Wheel Bearing Housing, Removing and Installing
Wheel Bearing Housing, Removing and Installing, FWD Vehicles
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Removing
- Measure dimension from center of wheel to lower edge of
wheel housing. Refer to
→ Chapter "Wheel Bearing in Curb Weig
© 2019-2026 Copyright www.auq3.net | 0.02
