Audi Q3 Owners & Service Manuals

Audi Q3: Wheel and Tire General Information

Audi Q3 (8U) 2011-2018 Service Manual / Wheel and Tire General Information

READ NEXT:

  Specifications for Retrofitting Wheel and Tire Combinations (Documents)

Legal Requirements The manufacturer is granted general type approval for the whole vehicle including all parts and for specific retrofitting (general type approval according to 20 StVZO (Motor V

  Wheel Bolt Tightening Specifications

Wheel Bolt Tightening Specifications, Current Models DANGER! To ensure that the wheel bolts fit correctly, be sure to use the correct wheel bolts specified for the model. The wheel bolts for eac

  Acceptable Tread Depth Variance

Model with Longitudinally Installed Engine Tread variance for models with a longitudinally installed engine, such as A4, A5, A6, A7, A8, Q5, Q7, ... The variance between the front and rear axle in

SEE MORE:

  Lower Transverse Link, Removing and Installing

Lower Transverse Link, Removing and Installing, FWD Vehicles Special tools and workshop equipment required Torque Wrench 1332 40-200Nm -VAG1332- Removing - Measure dimension from center of wheel to lower edge of wheel housing. Refer to → Chapter "Wheel Bearing in Curb Weig

  Vehicles with Break-Down Kit

Tire Sealant   WARNING If tire sealant was used, then the wheel electronics on that particular wheel must be replaced. Audi vehicles have either a spare wheel or a wheel repair kit, depending on equipment. The wheel repair kit is located in the luggage compartment, where the spar

© 2019-2026 Copyright www.auq3.net | 0.0111