Audi Q3: Driving
- Starting the vehicle
- Ignition key
- When driving
- Hill hold assist
- Manual shifting
- Accelerator pedal
- Emergency release operation
- Drive system
- Start/Stop system
- Starting and stopping the engine automatically
- Brakes
- Electromechanical parking brake
- Special driving situations
- Driving through water
READ NEXT:
Starting the vehicle
Convenience key
Applies to: vehicles with convenience key
Fig. 79 Center console: starting the engine
Requirement: the key must be in the vehicle.
Starting the engine
Press and hold the brake pedal
Ignition key
Applies to: vehicles with ignition lock
Fig. 80 Steering column: ignition lock
Starting the engine
Press the brake pedal.
Insert the ignition key into the ignition lock.
Turn the key briefly to p
When driving
Starting to drive, stopping, and parking
Starting from a stop
Press and hold the brake pedal.
Start the engine.
Select a gear.
Release the parking brake.
Release the brake pedal. The vehicle may
SEE MORE:
Steering Column
Overview - Steering Column
Note
Always replace corroded bolts/nuts.
1 - Instrument Panel Central Tube
2 - Shear Bolt
Tighten the shear bolt until head shears off.
3 - Steering Column
Removing and installing. Refer to
→ Chapter "Steerin
Repairing a 0.22 mm 2 Wire with Intermediate
Wire Section
Note
For repairing a 0.222 a repair
wire can be used as the intermediate wire with a cross section
of 0.35-mm2 or 0.5-mm2.
Procedure
- Free up the wire to be repaired at two places approximately
20 cm on both sides of the repair point.
Caution
Risk of damaging the
© 2019-2024 Copyright www.auq3.net
