Audi Q3: General, Technical data
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / General, Technical data
READ NEXT:
General Information
Suspension
1: Front/rear track width, applies only to
215/65/R16 standard tires on 6.5Jx16 ET33 rims.
Steering
Tire Types
General information on wheel/tire combinations, winter tires, snow c
Repair Information
Shock Absorber Leaks
Shock absorbers are frequently rejected and exchanged
because of leaks. Examinations on the test stand and on the
vehicle have shown that the replacement of a large number of
Disposal
Front Shock Absorbers, Venting and Emptying
Method A - Venting through Drill Holes
- Secure gas-filled shock absorber vertically in vise, with
piston rod facing down.
WARNING
WearSEE MORE:
Cleaning/changing wiper blades
Fig. 46 Windshield wipers: changing the wiper blades
Wiper blade replacement position
Switch off the ignition and hold the windshield
wiper lever in position 4 fig.
44 until
the windshield wiper moves into the wiper
blade replacement position.
To bring the windshield wipers into the normal
Drive Axle, Removing and Installing, Left Drive Axle with CV Joint, Inserted
with Inner Splines
Special tools and workshop equipment
required
Puller - Driveshaft -T10382-
Torque Wrench 1332 40-200Nm -VAG1332-
Slide Hammer Set -VW771-
Removing
- Loosen the drive axle threaded connection on the wheel side.
Refer to
→ Chapter "Drive Axle Threaded Connection, Loosenin
© 2019-2026 Copyright www.auq3.net | 0.0099
