Audi Q3: Heating, Ventilation & Air Conditioning

  Drive Axle, Removing and Installing, Right Drive Axle with CV Joint, Inserted with Inner Splines

Special tools and workshop equipment required Slide Hammer Set -VW771- Tensioning Strap -T10038- Puller - Driveshaft -T10382- Torque Wrench 1332 40-200Nm -VAG1332- Digital Torque Wrench -VAG1756A- Removing - Loosen the drive axle threaded connection on the wheel side. Refer

  Lock Cylinder, Removing and Installing

Create an assisting tool from a wire hook as follows: - Take a 1.5 mm diameter welding wire and bend the end to form an eye. - Then cut the welding wire. Dimension -a- = approximately 50 mm. - File the end of the wire hook into a point. Dimension -b- = 3 mm