Audi Q3: Brake System
Audi Q3 (8U) 2011-2018 Service Manual / Brake System
READ NEXT:
General, Technical data
Identification
Brake PR Numbers
The PR number on the vehicle data label describes which
brake system is installed in the vehicle.
Example of a Vehicle Data Sticker:
A - Front Brakes (e
General Information
ABS Repair Instructions
ABS malfunctions do not affect the brake system and the
booster. Conventional brake system stays operative even without
ABS. A change in braking behavior should be checkedSEE MORE:
Lower Rear Lid Trim Panel, Removing and Installing
Lower Rear Lid Trim Panel, Removing and Installing
Special tools and workshop equipment
required
Pry Lever -80-200-
Omega Clip Tool -T40280-
Removing
- If installed, remove the rear shelf. Refer to
→ Chapter "Rear Shelf Rear Section, Removing and Installing".
- Remove
Front Brake Pads, Removing and Installing
Brake Pads, Removing and Installing, 1LJ, 1ZD Brakes
If old brake pads are being replaced with new ones, then it is necessary
to check the brake rotor thickness for wear. Pay attention to the wear
specifications for the brake rotor.
Special tools and workshop equipment
required
Torque Wr
© 2019-2026 Copyright www.auq3.net | 0.0103
