Audi Q3: Antilock Brake System
READ NEXT:
General Information
ABS Repair Instructions
ABS malfunctions do not affect the brake system and the
booster. Conventional brake system stays operative even without
ABS. A change in braking behavior should be checked
Control Module and Hydraulic Unit
Overview - Control Module and Hydraulic Unit
1 - Brake Booster
Removing and installing, refer to
→ Chapter "Brake Booster, Removing and Installing".
2 - Brake Li
Sensors
Overview - Front Axle Speed Sensor
1 - Wheel Speed Sensor
Right Front ABS Wheel Speed Sensor -G45-/Left Front ABS Wheel Speed
Sensor -G47-
Removing and installing, refer to
→&
SEE MORE:
Glove Compartment Lamp -W6-, Removing and Installing
Removing
- Turn the light switch to position "0".
- Press in the tab -1- using a
flat-head screwdriver and pry out the glove compartment lamp
-2-.
- Disconnect the connector -3-.
Installing
Install in reverse order of removal. Note the following:
- Connect the connectors
Overview - Belt Pulley
Overview - Belt Pulley, Denso A/C Compressor, Version 1
Note
This type of belt pulley is installed on a "7 SEU 16" A/C
compressor.
1 - Bolt
20 Nm
Replacing
2 - Drive Plate
There are different versions. Refer to the Parts Catalog.
Removing and i
© 2019-2025 Copyright www.auq3.net
