Audi Q3: Glass, Window Regulators
READ NEXT:
Repair Information
Minimum Curing Time for Bonded Windows
WARNING
For safety reasons, use only electrically
non-conductive 2C-adhesive when installing windshield
and rear window using the materials li
Windshield
Overview - Windshield
Caution
On vehicles equipped with lane assist, the camera
must be recalibrated if the windshield has been
replaced. Refer to
→ Suspension, Wheels, Steeri
Side Windows
Overview - Rear Side Window
1 - Side Window
Pull or unclip the roof trim molding in the area of the side window
from the clip.
Window glass removing and installing. Refer to
→
SEE MORE:
Rear Lid Seal, Removing and Installing
1 - Rear Lid
2 - Rear Lid Seal
To remove, remove seal from body flange.
When installing, align the seal with the joint
-arrow- with the marking in the center of the vehicle.
Beginning at the seam, press the seal all around onto the body
flange.
3 - Bo
Repairing a 0.22 mm 2 Wire with Intermediate
Wire Section
Note
For repairing a 0.222 a repair
wire can be used as the intermediate wire with a cross section
of 0.35-mm2 or 0.5-mm2.
Procedure
- Free up the wire to be repaired at two places approximately
20 cm on both sides of the repair point.
Caution
Risk of damaging the
© 2019-2026 Copyright www.auq3.net
