Audi Q3: Steering
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Steering
READ NEXT:
Steering Wheel
Overview - Steering Wheel
1 - Steering Column Electronics Control Module -J527-
With Airbag Spiral Spring/Return Spring with Slip Ring -F138-
Removing and installing. Refer to
→
Steering Column
Overview - Steering Column
Note
Always replace corroded bolts/nuts.
1 - Instrument Panel Central Tube
2 - Shear Bolt
Tighten the shear bolt until head shears off
Steering Gear
Overview - Steering Gear
Part 1
1 - Bolt
6 Nm
For securing the wire
2 - Bolt
Tightening specification: -item 9-
Always replace if removed
Clean the threaded hSEE MORE:
Release Cable, Removing and Installing
Release Cable Coupling
- Remove clips -1- and lift the release
cables -8- and -9-
on both sides toward the hood latches.
- To remove the coupling -2-, release the
retainers -arrows- on the front of the lock
carrier -3- and push them to the rear out
of the bracket.
- Eng
Lower Control Arm, Removing and Installing
Special tools and workshop equipment
required
Locating Pins -T10096-
Torque Wrench 1332 40-200Nm -VAG1332-
Removing
- Before starting work, determine the measurement
-a-, for example with tape measure,
from center of wheel to lower edge of wheelhouse.
Note
Measurement
© 2019-2026 Copyright www.auq3.net | 0.0115
