Audi Q3: Passenger Protection, Airbags, Seat Belts
Audi Q3 (8U) 2011-2018 Service Manual / Body / Body Interior / Passenger Protection, Airbags, Seat Belts
- Component Location Overview - Seat Belts and Attaching Points
- Overview - Front Three-Point Seat Belt
- Overview - Rear Outer Three-Point Seat Belt
- Front Three-Point Seat Belt, Removing and Installing
- Rear Three-Point Seat Belt, Removing and Installing
- Front Belt End Fitting, Removing and Installing
- Child Seat Anchors
- Airbag System
- Airbag Control Module
- Battery Interrupt Igniter
- Driver Side Airbag
- Front Passenger Airbag
- Side Airbags
- Head Curtain Airbags
- Component Location Overview - Airbag Crash Sensors
- Driver Front Airbag Crash Sensor -G283-, Removing and Installing
- Driver Side Airbag Crash Sensor -G179-/ Front Passenger Side Airbag Crash Sensor -G180-, Removing and Installing
- Seat Position Sensor
- Belt Fastening Detection
- Passenger Occupant Detection System
- Deformation Element
READ NEXT:
Component Location Overview - Seat Belts and Attaching Points
1 - Front Seat Belt Latch
Overview. Refer to
→ Chapter "Overview - Front Seat Belt Latch".
2 - Front Passenger Seat Belt Tensioner Igniter 2 -N298-
Only USA a
Overview - Front Three-Point Seat Belt
Overview - Front Three-Point Seat Belt, USA and Canada Market
1 - Belt End Fitting Cover
Removing and installing. Refer to
→ Chapter "Front Belt End Fitting, Removing and Ins
Overview - Rear Outer Three-Point Seat Belt
1 - Belt Guide
Caution
Do not rotate bolts under any circumstances when removing
and installing belt guide. They are set by the manufacturer.
Replace the entire belt gui
SEE MORE:
General Information
Vehicles with a High Voltage System (Hybrid Vehicles)
Extremely Dangerous Due to High-Voltage
The high-voltage system is under high-voltage. Death or serious
bodily injury by electric shock.
- Individuals with electronic/medical life- and health sustaining
machines in or on their person
Generator, Checking
Perform Generator Test
Vehicle Diagnostic Tester is attached.
- Select the Diagnostic mode and
start the diagnostics.
- Select the tab Test Plan.
- Select Select Individual Tests
and choose the following sequence.
Body
Electrical Equipment
27 - Starter, voltage supply
© 2019-2025 Copyright www.auq3.net
